What You Should Know About Foxtel Installation in Australia

Foxtel is the leading pay television service provider in Australia. The company uses satellite and streaming to bring the best entertainment channels to your TV.

Previously, Foxtel used to provide services through the cable as well. However, it has recently decided to ditch cable services, forcing users to switch to satellite.

You need to buy a dish antenna to receive Foxtel satellite channels on your TV. In this guide, we will present all the information on how to properly set up the dish to receive Foxtel services.

Foxtel Installation Guide

Foxtel satellite dish installation is a lot more difficult as compared to TV antenna installation. The installation process consists of two steps: installing the satellite dish and tuning the digital decoder.

Keep in mind that all satellites are located above the equator in a geostationary orbit. The dish should point towards the south when the location is towards the north of the equator and vice versa.

To connect with Foxtel satellite services, you will need to point your satellite dish towards the north since we are located south of the equator.

Another important point that you need to remember regarding Foxtel installation is that the location where the satellite is placed should be easily accessible. You may need to clean dirt or snow from the dish or readjust it if it is out of alignment.

The location that you select for the dish should offer an unobstructed view of the sky. There should be no trees, buildings, or other structures in the line of sight.

The Foxtel satellite location should allow you to take a route that is straight and as close to the TV set as possible. However, the location should be away from utility services, especially the power lines.

Finally, make sure that the satellite is installed in a way that it could withstand strong winds. The satellite needs to be rigidly mounted so that it remains perfectly aligned. Any movement of the dish will reduce the signals.

Important Terms for Satellite Dish Installation

To align the dish properly, you should know about the following three key terms.

  • Azimuth — The terms refers to the position of the dish around a vertical axis. North is 0o and 360o, south is 180o, east is 90o, and west is 270o.
  • Elevation — This term refers to the angle between the local horizontal plane and the direction of the beam. The elevation angle is low when the dish points down the horizon and high when it points upwards.
  • Skew — The term refers to the tilt that is necessary to align with the orbital satellite. You need to set a skew only when you point to more than one satellite.

How to Setup Foxtel Services in Different Rooms?

You don’t need to buy a separate set up box to watch Foxtel channels in different rooms. A Foxtel Multistacker allows you to view the channels in up to four devices. A separate cable is required for each device.

The multitasker allows access to channels served on multiple transponders. You can access channels that are served on either horizontal or vertical transponders.

You can also buy specialized satellite equipment to gain access to Free-To-Air channels in addition to the Foxtel channels. This will allow you to maximize the entertainment value from your satellite dish.

An important device that you should buy to additional channels is to buy a low noise block down converters (LNB). The device is a combination of the local oscillator, frequency mixture, intermediate frequency amplifier, and low-noise amplifier. This device can be used to convert the signals received by the satellite dish to a manageable range. This device will allow you to get additional channels for free.

An LNB will allow you to receive channels from satellites that are in a different orbital position. The device will amplify and down-convert the received microwaves and sends the signal to a TV receiver. You may need to buy multiple LNB to receive all the content from a satellite service provider.

Installing LNB requires special consideration. The device contains an antenna probe that is located inside the feed-horn. This picks up the signal from the satellite dish so must be aligned correctly. You need to manually align the LNB in the horizontal or vertical direction so that it lines up with the signals sent by the orbital satellite.

Leave a Comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.