How To Change Your Car Rims

Most car enthusiasts change the rims of their car mainly because they want to enhance its aesthetic appeal. Advancement in technology has made it possible for people to customize their set of rims according to their own preferences. This can be either through a unique design or build which will make it stand out from the rest.

People can easily judge your character simply by just looking at the type and build of your car. The process of installing new rims isn’t as complicated as most people believe it to be.

All you need to have is the correct set of tools and you’ll be good to go. Some of these tools include a car jack, socket wrench, torque wrench, oil, air compressor, and a flat-head screwdriver.

Here are a couple of steps that you can follow to ensure that everything goes well when replacing your car’s rims at home:

Step 1. Lift the Wheel off the Ground

Make sure that the car is on flat level ground and place a jack under the car near the tire.

Use the car jack to slowly raise the wheel until it is slightly off the ground.

Loosen up the lug nuts and continue to pump up the jack to raise the wheel higher.

Now take a socket wrench and use it to completely remove the nuts. Make sure not to lose them as you’ll need them with the new rims.

Remove the tire and place it on the ground.

Step 2. Remove the Old Rim

To deflate the tire, you can try pushing the pressure needle down the valve stem.

Once this is done go ahead and use a flat-head screwdriver to pry between the edges of the rim and tire. To make work easier you can use oil which will reduce the friction and make it pop out faster.

Cheap rims tend to bend when you use too much force. This makes it impossible for you to re-use them and sheds quite a lot from the lifespan you’d want your rims to have.

Step 3. Attach the New Rim

Place the tire around the new rim and fill it with enough air by using an air compressor.

Carefully place the tire on the hub and use your hands to screw in the nuts.

Pick up the torque wrench and use it to tighten up the bolt.

To get the specific torque wrench for your vehicle, be sure to visit your local auto shop. They are a bit pricey and you’ll have to spend over 90$ to get a good quality torque wrench.

After you’re done tightening up the bolts, be sure to reset the torque wrench to zero. This makes sure it remains calibrated over a longer period of time.

Step 4. Lower the Car to the Ground

Carefully lower the car to the ground and proceed to remove the car jack gently.

Attach the hubcap and repeat the same process on the rest of the wheels.

Be sure to do a test drive to make sure all the wheels are properly aligned. This will make sure that the rims won’t pop off when driving. Maintain a low speed when doing this.

By now it’s ok to say that changing your car’s rims isn’t hard. It’s something that you can easily do on your own. Just begin by purchasing a set that’s compatible and durable. A good set of rims will definitely enhance your driving experience by making it more worthwhile.

In case you’re still doubtful of the installation process, don’t hesitate to visit your local auto shop.

Leave a Comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.